No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Output Debugging Messages to the Console

Configuring the Device to Output Debugging Messages to the Console

Context

After debugging messages are output to the console, you can view debugging messages on the console (host from which you can log in to the device through the console interface) to monitor device running.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run info-center console channel { channel-number | channel-name }

    A channel used by the device to output debugging messages to the console is specified.

    By default, the device uses channel 0 to output debugging messages to the console.

  3. Run info-center source { module-name | default } channel { channel-number | channel-name } debug { state { off | on } | level severity } *

    A rule for outputting debugging messages to a channel is set.

    By default, channel 0 is enabled to output debugging messages and the lowest severity is debugging.

  4. Run quit

    Return to the user view.

  5. Run terminal monitor

    Display of logs, traps, and debugging message output is enabled on the user terminal.

    By default, console display is enabled and terminal display is disabled.

  6. Run terminal debugging

    Debugging message display is enabled on the user terminal.

    By default, debugging message display is disabled on the user terminal.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 25301

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next