No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - Device Management

This document describes the configurations of Device Management, including device status query, hardware management, Stack, SVF, cloud-based management, PoE, OPS, energy-saving management, information center, fault management, NTP.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Performing Software Configurations

Performing Software Configurations


When using service port connections to establish a stack, you need to configure logical stack ports. You are advised to configure stack IDs and stack priorities to facilitate user management.

A logical stack port takes effect only after stack member ports are added to it. Multiple stack member ports can be added to a logical stack port to improve stack link bandwidth and reliability.


  1. Run the system-view command to enter the system view.
  2. Run the interface stack-port member-id/port-id command to create a logical stack port and enter the logical stack port view.
  3. Run the port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command to configure a service port as a stack member port and add it to the logical stack port.

    1. A stack member port supports only stack-related functions, and other functions cannot be configured on the port. All the commands irrelevant to the stack function are unavailable in the interface view, and only basic configuration commands such as description (interface view) are retained.

    2. After configuring a service port of a switch as a stack member port, you are advised to save the configuration if this service port has been referenced by other commands. Otherwise, the commands that reference this service port may be retained after the switch restarts.

    3. To restore a stack member port as a service port, run the shutdown interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> command in the logical stack port view to shut down the stack member port, and then run the undo port interface { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-10> enable command in this view.

  4. Run the quit command to return to the system view.
  5. (Optional) Run the stack slot slot-id renumber new-slot-id command to configure a stack ID for the switch.

    By default, the stack ID of a switch is 0.

    The configuration takes effect after the switch is restarted.

  6. (Optional) Run the stack slot slot-id priority priority command to configure a stack priority for the switch.

    By default, the stack priority of a member switch is 100.

  7. (Optional) Run the display stack configuration [ slot slot-id ] command to check the stack configuration on a member switch.
Updated: 2019-04-20

Document ID: EDOC1100066159

Views: 32176

Downloads: 3

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next