No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPFv3 Area Configuration

Verifying the OSPFv3 Area Configuration

Prerequisites

The configurations for an OSPFv3 area have been completed.

Procedure

  • Run the following commands to check OSPFv3 LSDB information:

    • display ospfv3 [ process-id ] lsdb [ area area-id ] [ originate-router advertising-router-id | self-originate ] [ { router | network | inter-router [ asbr-router asbr-router-id ] | { inter-prefix | nssa } [ ipv6-address prefix-length ] | link | intra-prefix | grace } [ link-state-id ] ]

    • display ospfv3 [ process-id ] lsdb [ originate-router advertising-router-id | self-originate ] external [ ipv6-address prefix-length ] [ link-state-id ]

  • Run the following commands to check the OSPFv3 routing table:

    • display ospfv3 [ process-id ] routing uninstalled

    • display ospfv3 [ process-id ] routing [ ipv6-address prefix-length | abr-routes | asbr-routes | intra-routes | inter-routes | ase-routes | nssa-routes | [ statistics ] [ uninstalled ] ]

  • Run the display ospfv3 [ process-id ] vlink command to check information about OSPFv3 virtual links.
  • Run the display ospfv3 [ process-id ] vlink command to check information about OSPFv3 virtual links.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 27177

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next