No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Basic RIPng Function Configuration

Verifying the Basic RIPng Function Configuration


  • Run the display ripng [ process-id | vpn-instance vpn-instance-name ] command to check the configuration of the specified RIPng process.
  • Run the display ripng process-id route command to check all the RIPng routes that are learned from other switches.
  • Run the display default-parameter ripng command to check the default RIPng configuration.
  • Run the display ripng process-id statistics interface { all | interface-type interface-number [ neighbor neighbor-ipv6-address | verbose ] } command to check statistics about RIPng interfaces.
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 29499

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next