No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Smart-discover

Configuring Smart-discover

Context

If the neighbor status of a switch changes or the DR/BDR on a multi-access network (broadcast or NBMA network) changes before Smart-discover is configured, the switch does not send Hello packets to its neighbor until the Hello timer expires. This slows down the establishment of neighbor relationships between devices. To resolve this problem, you can configure Smart-discover to allow the switch to send Hello packets to its neighbor immediately without waiting for the expiration of the Hello timer.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The OSPF interface view is displayed.

  3. Run ospf smart-discover

    Smart-discover is configured on the interface.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 26034

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next