No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Interface to Insert the Actual MTU into DD Packets

Configuring an Interface to Insert the Actual MTU into DD Packets

Context

The default maximum transmission unit (MTU) is 0.

To improve compatibility with a non-Huawei device, an OSPF-enabled Huawei device adds the MTU 0 in DD packets to be sent and does not check the MTUs in received DD packets, allowing an OSPF neighbor relationship to be set up even if the two ends have different MTU settings.

However, under the default configuration, the non-Huawei device may discard an OSPF packet received from the Huawei device if the packet's actual MTU is greater than the MTU of the non-Huawei device. If the discarded packet is an LSU, an OSPF neighbor relationship can still be set up, but the route carried in the LSU fails to be learned, causing service interruptions.

To resolve this issue, run the ospf mtu-enable command to configure an interface to add the actual MTU in DD packets to be sent and check whether the MTU in a received DD packet is greater than the local MTU. If the interface MTU settings of the local and remote ends are different, an OSPF neighbor relationship cannot enter the Full state. In this manner, MTU inconsistency can then be identified in time.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The OSPF interface view is displayed.

  3. Run ospf mtu-enable

    The interface is configured to insert the actual MTU into DD packets and check whether the MTU in DD packets from the neighbor exceeds the MTU of the local end.

    By default, the MTU in DD packets sent by an interface is 0.

    Performing this procedure causes the re-establishment of neighbor relationships.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 26555

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next