No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting an OSPF Packet Retransmission Limit

Setting an OSPF Packet Retransmission Limit


After an OSPF switch sends DD, LSU, or LSR packets but does not receive any LSAck packet from a neighbor within a specified time, the switch retransmits the packets. If the number of packet retransmissions reaches a specified limit, the switch tears down the adjacency relationship with the neighbor.


  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run retransmission-limit [ max-number ]

    An OSPF packet retransmission limit is set.

    By default, no OSPF packet retransmission limit is set. If an OSPF packet retransmission limit is set, the default value of max-number is 30.

Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 29904

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next