No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Entering an OSPFv3 Area View

Entering an OSPFv3 Area View

Context

When configuring the switches in the same area, uniformly plan the configuration data. Otherwise, neighbor switches cannot exchange information with each other. This causes congestion of routing information or routing loops.

Perform the following operations on the switch that runs OSPFv3.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run area area-id

    The OSPFv3 area view is displayed.

    The area ID can be entered as a decimal integer or in the IPv4 address format. However, it is displayed in the IPv4 address format.

    An OSPFv3 area cannot be manually deleted. It is automatically deleted only after all the configurations in the area view are cleared.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 28846

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next