No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPFv3 Trap

Configuring OSPFv3 Trap


Perform the following operations on the OSPFv3 switch.


  1. Run system-view

    The system view is displayed.

  2. Run snmp-agent trap enable feature-name ospfv3 [ trap-name { ifconfigerror | ifrxbadpacket | ifstatechange | nbrrestarthelperstatuschange | nbrstatechange | nssatranslatorstatuschange | restartstatuschange | virtifconfigerror | virtifrxbadpacket | virtifstatechange | virtnbrrestarthelperstatuschange | virtnbrstatechange } ]

    The trap function for the OSPFv3 module is enabled.

Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 33788

Downloads: 3

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next