No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RIPng on Interfaces

Enabling RIPng on Interfaces

Context

After RIPng is enabled on an interface, devices can exchange RIPng routing information through this interface.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ripng process-id enable

    RIPng is enabled on the specified interface.

    NOTE:

    If IPv6 is not enabled on this interface, this command does not take effect on this interface.

    If RIPng needs to be enabled on multiple interfaces of a switch, repeat steps 2 and 3.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 27275

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next