No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Disabling Receiving of RIPng Packets on an Interface

Disabling Receiving of RIPng Packets on an Interface

Context

When a device running RIPng is connected to a network running other routing protocols, you can run the undo ripng input command on the interface that connects the device to the network to prevent the interface from receiving useless packets from the network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run undo ripng input

    The interface is disabled from receiving RIPng packets.

    By default, an interface is allowed to receive RIPng packets.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 33461

Downloads: 3

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next