No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Permanent Advertisement of IPv4 Static Routes

(Optional) Configuring Permanent Advertisement of IPv4 Static Routes


Link connectivity directly affects network stability and availability. Monitoring link status is an important part of network maintenance. If service traffic needs to be forwarded along a specified path, you can monitor the status of the path by pinging the destination addresses of static routes. In this manner, you can monitor services at a very low cost.

After permanent advertisement of static routes is configured, static routes always take effect regardless of the outbound interface status. In this case, the system forwards ping packets along a specified path only, which helps monitor the link status of the path.


  1. Run system-view

    The system view is displayed.

  2. Run ip route-static ip-address { mask | mask-length } { nexthop-address | interface-type interface-number [ nexthop-address ] | vpn-instance vpn-instance-name nexthop-address } permanent

    Permanent advertisement of IPv4 static routes is configured.

    By default, permanent advertisement of IPv4 static routes is not configured.

Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 33650

Downloads: 3

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next