No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Suppressing an Interface from Sending and Receiving OSPFv3 Packets

Suppressing an Interface from Sending and Receiving OSPFv3 Packets


To prevent a switch from advertising routes to the switch on a certain network and from importing the routes of other switches, suppress the interface on which OSPFv3 is enabled from receiving and sending OSPFv3 packets.

Perform the following operations on the switch that runs OSPFv3.


  1. Run system-view

    The system view is displayed.

  2. Run ospfv3 [ process-id ]

    The OSPFv3 view is displayed.

  3. Run silent-interface { all | interface-type interface-number }

    The interface is suppressed from sending and receiving OSPFv3 packets.

Follow-up Procedure

Different processes can suppress the same interface from sending and receiving OSPFv3 packets, but the silent-interface command is valid only for the OSPFv3 interface on which the specified process is enabled. It does not take effect on the interface of other processes.

After an OSPFv3 interface is set to silent, the interface can still advertise its direct routes using the Intra-Area-Prefix-LSA of the same switch. No OSPFv3 neighbor relationship can be set up on the interface. This enhances OSPFv3 adaptability.

Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 34608

Downloads: 3

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next