No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Optimizing an OSPFv3 Network

Optimizing an OSPFv3 Network

Applicable Environment

Adjust the OSPFv3 timer to change the convergence speed of an OSPFv3 network and the network overload caused by protocol packets. On low-speed links, take into account the delay in transmitting LSAs on the interface. Adjust the SPF calculation interval to mitigate resource consumption caused by frequent network changes.

Specify the DR priority of an interface to affect DR and BDR election in a broadcast network.

Pre-configuration Tasks

Before optimizing an OSPFv3 network, configure basic OSPFv3 functions.

Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 26578

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next