No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IPv4 Static Routes

Configuring IPv4 Static Routes

Pre-configuration Tasks

Before configuring IPv4 static routes, configure link layer parameters and IP addresses for interfaces to ensure network-layer communication between neighbor nodes.

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the IPv4 Static Route Configuration) as required and in any sequence.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 29992

Downloads: 3

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next