No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting an Interval for Receiving LSAs

Setting an Interval for Receiving LSAs

Context

OSPF stipulates that LSAs are received at an interval of 1s to prevent network connections or frequent route flapping from consuming excessive network bandwidth or device resources.

On a stable network where routes need to converge fast, you can set the LSA receipt interval to 0s so that the topology or route changes can be immediately advertised over the network through LSAs, thereby speeding up route convergence.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run lsa-arrival-interval { interval | intelligent-timer max-interval start-interval hold-interval }

    The interval for receiving LSAs is set.

    • The parameter interval specifies the interval for receiving LSAs, in milliseconds.
    • The parameter intelligent-timer indicates that an intelligent timer is used to set the interval for receiving Router-LSAs and Network-LSAs.
    • The parameter max-interval specifies the maximum interval for receiving LSAs, in milliseconds.
    • The parameter start-interval specifies the initial interval for receiving LSAs, in milliseconds.
    • The parameter hold-interval specifies the hold interval for receiving LSAs, in milliseconds.
    By default, an intelligent timer is enabled. After an intelligent timer is enabled, the default maximum interval for receiving LSAs is 1000 ms, the default initial interval is 500 ms, and the default hold interval is 500 ms. The mechanism of the intelligent timer is as follows:
    1. The initial interval for receiving LSAs is specified by start-interval.
    2. The interval for the nth (n ≥ 2) LSA receipt is equal to hold-interval x 2(n-2).
    3. When the interval specified by hold-interval x 2(n-2) reaches the maximum interval specified by max-interval, the maximum interval is used for the subsequent three LSA receipts. Then, OSPF goes back to step 3.a and receives LSAs at the initial interval specified by start-interval.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 26086

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next