No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - IP Unicast Routing

This document describes the configurations of IP Unicast Routing, including IP Routing, Static Route, RIP, RIPng, OSPF, OSPFv3, Routing Policy, IP Routing Table Management, and PBR.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Area Authentication Mode

Configuring an Area Authentication Mode

Context

In area authentication, all switches in an area must use the same area authentication mode and password. For example, all switches in Area 0 are configured to use the simple authentication mode and a password of abc.

If plain is selected in the area authentication configuration, the password is stored in plaintext in the configuration file. For security purposes, you are advised to select cipher to store the password in ciphertext.

Simple authentication, MD5 authentication, and HMAC-MD5 ciphertext authentication have potential security risks. HMAC-SHA256 ciphertext authentication is recommended.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run area area-id

    The OSPF area view is displayed.

  4. Run any of the following commands to configure an authentication mode for the OSPF area as required:

    • Run authentication-mode simple [ plain plain-text | [ cipher ] cipher-text ]

      Simple authentication is configured for the OSPF area.

      • plain: indicates that the password is stored in plaintext.
      • cipher: indicates that the password is stored in ciphertext. For MD5 authentication or HMAC-MD5 authentication, the password is stored in ciphertext by default.
    • Run authentication-mode { md5 | hmac-md5 | hmac-sha256 } [ key-id { plain plain-text | [ cipher ] cipher-text } ]

      An authentication mode is configured for the OSPF area.

      • md5: indicates that MD5 ciphertext authentication is used.

      • hmac-md5: indicates that HMAC-MD5 ciphertext authentication is used.
      • hmac-sha256: indicates that HMAC-SHA256 ciphertext authentication is used.
      • key-id: specifies the authentication key ID in ciphertext authentication.

Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066165

Views: 25782

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next