No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - User Access and Authentication

This document describes the configurations of User Access and Authentication Configuration, including AAA, NAC, and Policy Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Session Timeout Interval for Built-in Portal Authentication Users

(Optional) Configuring the Session Timeout Interval for Built-in Portal Authentication Users


When built-in Portal authentication is used for users and the device functions as a built-in Portal server, you can configure the session timeout interval for the users. The users are disconnected after the specified session timeout interval. To connect to the network again, the users need to be re-authenticated.

The session timeout interval for built-in Portal authentication users is calculated based on the device time. For example, if the session timeout interval is 6 hours and the device time is 2014-09-01 02:00:00 when a user was connected, the user should be disconnected at 2014-09-01 08:00:00. Therefore, ensure that the device time is correct after the session timeout interval is configured for users. If the device time is incorrect, users may fail to be connected or disconnected properly. You can run the display clock command to check the device time and the clock datetime HH:MM:SS YYYY-MM-DD command to configure the time.


This function applies only to built-in Portal servers.


  1. Run system-view

    The system view is displayed.

  2. Run portal local-server timer session-timeout interval

    The session timeout interval is configured for built-in Portal authentication users.

    The default session timeout interval is 8 hours for built-in Portal authentication users.

Updated: 2019-04-20

Document ID: EDOC1100066170

Views: 23056

Downloads: 6

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next