No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Configuration Guide - User Access and Authentication

This document describes the configurations of User Access and Authentication Configuration, including AAA, NAC, and Policy Association.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the 802.1X Authentication Configuration

Verifying the 802.1X Authentication Configuration

Context

You can run the commands to check the configured parameters after completing the 802.1X authentication configuration.

Procedure

  • Run the display dot1x [ statistics ] [ interface { interface-type interface-number1 [ to interface-number2 ] } &<1-10> ] command to check the 802.1X authentication configuration.
  • Run the display mac-address authen [ interface-type interface-number | vlan vlan-id ] * [ verbose ] command to check the current authen MAC address entries in the system.
  • Run the display user-group [ group-name ] command to check the user group configuration.
  • Run the display access-user command to check information about online NAC users.
  • Run the display aaa statistics access-type-authenreq command to verify the number of authentication requests.
  • Run the display port connection-type access all command to check all current downlink interfaces on the device.
  • Run the display dot1x quiet-user { all | mac-address mac-address } command to check information about 802.1X authentication users who are quieted.
  • Run the display access-user dot1x-identity statistics command to display statistics about Identity packets for 802.1X authentication on a switch.
Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100066170

Views: 27232

Downloads: 7

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next