No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - User Access and Authentication

This document describes the configurations of User Access and Authentication Configuration, including AAA, NAC, and Policy Association.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Timers for 802.1X Authentication

(Optional) Configuring Timers for 802.1X Authentication


During 802.1X authentication, multiple timers implement systematic interactions between access users, access devices, and the authentication server. You can change the values of timers by running the dot1x timer command to adjust the interaction process. This command is necessary in special network environments. It is recommended that you retain the default settings of the timers. You can configure the following types of timers in 802.1X authentication:
  • Client timeout timer (client-timeout): After sending an EAP-Request/MD5-Challenge request packet to the client, the device starts this timer. If the client does not respond within the period set by the timer, the device retransmits the packet.
  • Authentication request timeout timer (tx-period): This timer defines two intervals. After sending an EAP-Request/Identity request packet to the client, the device starts the timer. If the client does not respond within the first interval set by the timer, the device retransmits the authentication request packet. The device multicasts the EAP-Request/Identity request packet at the second interval to detect the client that does not actively send the EAPoL-Start connection request packet for compatibility. The timer defines the interval for sending the multicast packet.


  1. Run system-view

    The system view is displayed.

  2. Run dot1x timer { client-timeout client-timeout-value | tx-period tx-period-value }

    The 802.1X timers are configured.

    By default, client-timeout is set to 5 seconds; tx-period is set to 30 seconds.


    The client timeout timer, and the authentication request timeout timer are enabled by default.

Updated: 2019-04-20

Document ID: EDOC1100066170

Views: 26936

Downloads: 7

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next