No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Configuration Guide - User Access and Authentication

This document describes the configurations of User Access and Authentication Configuration, including AAA, NAC, and Policy Association.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Combined Authentication

Combined Authentication

As shown in Figure 3-13, many PCs and printers are connected to interface1 of the access device. The access device needs to control user terminals' network access to ensure network security. Only authenticated users are allowed to access network resources authorized by the administrator.

Figure 3-13  Typical application of combined authentication

In situations where some clients, such as printers, only support MAC address authentication, some hosts support 802.1X authentication because they have 802.1X client software installed, and some user hosts require Portal authentication using web browsers. If 802.1X authentication, MAC address authentication, and Portal authentication are all used on a single network, the administrator must configure all these authentication modes on interface 1 so users can use the proper authentication mode to connect to the network.

Updated: 2019-04-20

Document ID: EDOC1100066170

Views: 22746

Downloads: 6

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next