No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R013C00 Web-based Configuration Guide

This document describes how to configure and maintain devices through the web NMS client, including device status statistics, SVF, interface, Ethernet switching, IP service, IP routing, security, ACL, AAA, system management, QoS, diagnosis service, and EasyDeploy.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Port Isolation

Port Isolation

Bidirectional Isolation

Procedure

  • Create bidirectional isolation.
    1. Choose Configuration > Security Services > Port Isolation and click the Bidirectional Isolation tab.
    2. Click Create to create bidirectional isolation, as shown in Figure 5-134.

      Figure 5-134  Create bidirectional isolation

    3. Click Select Interface to select the interface where bidirectional isolation needs to be configured, and click OK.
    4. Click to complete the configuration.
  • Delete bidirectional isolation.
    1. Choose Configuration > Security Services > Port Isolation and click the Bidirectional Isolation tab.
    2. Select the isolation group that you want to delete and click Delete. The system asks you whether to delete the group.
    3. Click OK.

Unidirectional Isolation

Procedure

  • Create unidirectional isolation.
    1. Choose Configuration > Security Services > Port Isolation and click the Unidirectional Isolation tab.
    2. Click the record of the required interface. The Select Interface button is available in the Interface Name column, as shown in Figure 5-135.

      Figure 5-135  Create unidirectional isolation

    3. Click Select Interface to select the interface where unidirectional isolation needs to be configured, and click OK.
    4. Click to complete the configuration.
  • Delete unidirectional isolation.
    1. Choose Configuration > Security Services > Port Isolation and click the Unidirectional Isolation tab.
    2. Select the data that you want to delete and click Clear. The system asks you whether to delete the group.
    3. Click OK.
Translation
Download
Updated: 2019-04-08

Document ID: EDOC1100066172

Views: 8003

Downloads: 13

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next