No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R013C00 Web-based Configuration Guide

This document describes how to configure and maintain devices through the web NMS client, including device status statistics, SVF, interface, Ethernet switching, IP service, IP routing, security, ACL, AAA, system management, QoS, diagnosis service, and EasyDeploy.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Trace Route

Trace Route


The Tracert command, also called Trace Route, helps you check the IP addresses and the number of gateways between the source and the destination. Tracert is used to check network connectivity and locate network faults.


  1. Choose Diagnosis > Trace Route to access the Trace Route page, as shown in Figure 6-4.

    Figure 6-4  Trace Route

  2. Enter the IP address in the Trace Route text box and click Start. The Layer 3 devices where packets pass through between the source host and the destination host are displayed.

    • The output of the tracert command includes IP addresses of all the gateways through which the packet reaches the destination. If one gateway sends back a packet indicating TTL timeout, * is displayed.
    • The tracert test may take a long time.

Updated: 2019-04-08

Document ID: EDOC1100066172

Views: 7299

Downloads: 11

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next