No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V5 7.0 Command Reference 03

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change datasync config

change datasync config

Function

The change datasync config command is used to change the remote synchronization (InfoMigrator) configuration.

Format

change datasync config [ bwlimit=? ] [ dayofmonth=? ] [ dayofweek=? ] [direction=? ] [ hour=? ] [ minute=? ]

Parameters

Parameter

Description

Value

bwlimit Upper limit of bandwidth use for a single node during synchronization.

The value is an integer between "0" and "104,857,600" expressed in KByte/s. If the value is set to "0", there is no limit on the bandwidth.

dayofmonth Days of a month when data synchronization is performed.

The value is in one of the following formats: "*", "a-b", "a,b,c…", "*/a", or "a-b/c".

The values of a, b, and c are integers between "1" and "31".

"*" indicates all days of a month.

dayofweek Days of a week when data synchronization is performed.

The value is in one of the following formats: "*", "a-b", "a,b,c…", "*/a", or "a-b/c".

The values of a, b, and c are integers between "0" and "6".

"*" indicates all days of a week.

direction Synchronization direction.

The value is "pull" or "push", where:

  • "pull": to copy data from the backup directory to the local directory to restore data.
  • "push": to copy data from the local directory to the backup directory to back up data.
hour Hours of the way when data synchronization is performed.

The value is in one of the following formats: "*", "a-b", "a,b,c…", "*/a", or "a-b/c".

The values of a, b, and c are integers between "0" and "23". For example, "3-4" indicates that data is synchronized between 3:00 and 4:00 every day. "6,9,12" indicates that data is synchronized at 6:00, 9:00, and 12:00. "*/3" indicates that data is synchronized every three hours. "3-12/3" indicates that data is synchronized every three hours between 3:00 and 12:00.

"*" indicates all hours of a day.

minute Minute of an hour when data synchronization is performed.

The value is an integer between "0" and "59". For example, value "10" indicates that data is synchronized at the tenth minute of each hour.

Level

Administrator

Usage Guidelines

  • The configuration is effective for all remote synchronization tasks.
  • The minimum interval is 5 minutes.

Example

Change the remote synchronization time.

admin:/>change datasync config minute=10 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-05-07

Document ID: EDOC1100067955

Views: 24734

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next