No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 9000 V5 7.0 Command Reference 03

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change alarmlevel definition

change alarmlevel definition


The change alarmlevel definition command is used to change an alarm severity.


change alarmlevel definition < alarm_id > < alarm_level > [ report_snmp ] < report_dm >





alarm_id Alarm ID.

The value contains 1 to 127 letters, digits, hyphens (-), underscores (_), and periods (.).

alarm_level Alarm severity.
  • info: info.
  • warning: warning.
  • major: major.
  • critical: critical.
report_snmp Indicates whether the alarm is reported to SNMP.
  • true: the alarm is reported to SNMP.
  • false: the alarm is not reported to SNMP.
report_dm Indicates whether the alarm is reported to DeviceManager.
  • true: the alarm is reported to DeviceManager.
  • false: the alarm is not reported to DeviceManager.



Usage Guidelines

1.This command is used to set whether the alarm is reported to SNMP and DeviceManager.

2.If you do not want to change the alarm severity,run the show alarmlevel definition [alarm_id] command to acquire the default alarm severity, and enter the default alarm severity. If the alarm severity is changed, run the recover alarmlevel definition <id_list> to recover it to the original default alarm severity.

3.In the [ report_snmp ] < report_dm > parameter combinations, only following three cases are valid: alarms are fully reported,no alarms are reported, and alarms are only reported to DeviceManager. Alarms only reporting to SNMP are not supported.


Change an alarm severity.

admin:/>change alarmlevel definition 1073872897 warning true true
Command executed successfully.

System Response


Updated: 2019-05-07

Document ID: EDOC1100067955

Views: 24781

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next