No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 9000 V5 7.0 Command Reference 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_replication invalid

change remote_replication invalid


The change remote_replication invalid command is used to make a remote replication pair invalid.


change remote_replication invalid <id>





id Pair ID.

The value is a combination of numbers, and is 1 to 128 characters in length.


Resource administrator

Usage Guidelines

If a directory snapshot fails to be rolled back and cannot be recovered, you can run this command to make the remote replication pair invalid. Then you can delete the remote replication pair.


To make a remote replication pair invalid, run the following command.

admin:/>change remote_replication invalid 10382957377019552493
DANGER: You are about to set the remote replication pair to the invalid status.
This operation will cause this pair to become invalid.
Before performing this operation, ensure that this operation is necessary.
Have you read warning message carefully?(y/n)y
Are you sure you want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-05-07

Document ID: EDOC1100067955

Views: 25325

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next