No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


OceanStor 9000 V5 7.0 Command Reference 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change task

change task


The change task command is used to change task attributes, task execution periods, and task description.


change task < task_id > [ dispatchTime=? ] [ impactId=? ] [ jobInput=? ] [ name=? ] [ priority=? ]





task_id Task ID.

The value is a combination of numbers, letters, underscores (_), and periods (.) and is 1 to 127 characters in length.

dispatchTime Execution frequency or delay period.

This operand is valid only when "JobDispatchType" is set to "0" or "2". For example, if the value is set to "10 minutes", periodic tasks will be scheduled every 10 minutes, and one-time tasks will be scheduled in 10 minutes.

impactId Impact level.

The value is "1", "2", or "3", where:

  • "1": High.
  • "2": Medium.
  • "3": Low.
You can also use your custom priority.
jobInput Task input parameter.

The value depends on the specific task and does not support Chinese characters.

name Task name.

The value can contain only 1 to 63 letters, digits, periods (.), underscores (_), hyphens (-), and commas (,).

priority Priority.

The value ranges between "1" and "100" with "1" and "100" indicating the highest and lowest priority respectively. You must enter a valid value for existing tasks.



Usage Guidelines

  • For periodic tasks (dispatchType=1 or dispatchType=2), the delay period cannot be modified.
  • For one-time tasks (dispatchType=0) that have completed or been cancelled (runningStatus=completed or runningStatus=cancelled), the delay period cannot be modified.
  • For one-time tasks, value of dispatchTime cannot be modified.


Change the task input parameters.

admin:/>change task 9223372036854776066 jobInput=example
WARNING: You are about to modify some attributes of Data scrubing. Are you sure you want to continue?
Have you read warning message carefully?(y/n)y
Are you sure you want to perform the operation?(y/n)y
Command executed successfully.

System Response


Updated: 2019-05-07

Document ID: EDOC1100067955

Views: 25300

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next