Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Desktop Device
This chapter provides the cabinet-mounting, workbench-mounting, wall-mounting, and cable connection methods of the USG6510E, USG6510E-POE, USG6530E.
- Mounting a Device to a Specified Location
The USG6510E, USG6510E-POE, USG6530E can be mounted in a 19-inch standard cabinet. When no cabinet is available, install the USG6510E, USG6510E-POE, USG6530E on a workbench or a wall. - Connecting a PGND Cable
Connecting the PGND cable of a USG6510E, USG6510E-POE, USG6530E correctly is a key measure of surge protection and resistance to interference. Before using the USG6510E, USG6510E-POE, USG6530E, correctly connect the PGND cable. Otherwise, the USG may be damaged. - Installing a Micro SD Card
This section describes how to install a micro SD card for the first time to avoid damages. - Connecting a Console Cable
After connecting a PC to the console port of a USG6510E, USG6510E-POE, USG6530E with a console cable, you can use the terminal emulation program on the PC to access the command configuration interface of the USG6510E, USG6510E-POE, USG6530E. - Connecting an Ethernet Cable
Based on the network plan, you can connect one end of an Ethernet cable to the Ethernet port of a USG6510E, USG6510E-POE, USG6530E and the other end to the Ethernet port of the peer device. - Installing Optical Transceivers and Connecting Optical Fibers
This section describes how to install optical transceivers on the SFP or SFP+ ports and connect them to the ports of the peer device using optical fibers according to the network plan. - Connecting a Power Adapter
A power adapter can be used to supply power for a USG6510E, USG6510E-POE, USG6530E. Prepare an AC power cable to connect the power connector and the power source of the equipment room. - Powering On or Off the USG6510E, USG6510E-POE, USG6530E
This section describes how to power on or off the USG6510E, USG6510E-POE, USG6530E. To ensure the normal start and security of the USG6510E, USG6510E-POE, USG6530E, strictly follow the operation guide to power on or off the USG6510E, USG6510E-POE, USG6530E.