Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Micro SD Card
This section describes how to install a micro SD card for the first time to avoid damages.
Precautions
- Micro SD cards are optional and are not delivered with the device. If required, purchase the micro SD card (part number: 06010308) from Huawei. The micro SD card model is SDSDQAE-064G, the capacity is 64 GB, and dimensions (H x W x D) are 1 mm x 15 mm x 11 mm (0.04 in. x 0.59 in. x 0.43 in.).
- The micro SD card can be installed no matter the device is powered off or the device is running. The installation methods are the same. In this section, the micro SD card is installed when the device is powered off.
- To replace the micro SD card when the USG is powered on, you must run the sd-card offline command in the system view first. After the system displays a message indicating that the micro SD card is offline, remove the micro SD card. Otherwise, the micro SD card might be damaged, and the data may be lost. For details, see Replacing a Micro SD Card (USG6510E, USG6510E-POE, USG6530E).
- Make sure that you have worn an ESD wrist strap and the strap is well grounded before you hold the micro SD card. Otherwise, the micro SD card may be damaged.
Procedure
- Determine the slot (the slot with a "micro SD" mark on the rear panel) for installing the micro SD card.
- Install the micro SD card and anti-theft board.
- Note that the micro SD card must be installed with the face with words upwards.
- Do not use too much force; otherwise the micro SD or micro SD card slot might be damaged.
- Insert the micro SD along the guide rail to the micro SD card slot.
- When you hear a click, the micro SD card is in position.
- Hook the locating hook on the anti-theft board to the locating hole of the rear panel and tighten the captive screw on the anti-theft board.
Figure 5-13 Installing the micro SD card and anti-theft board
Follow-up Procedure
After the micro SD card is installed, power on the USG and run the display sd-card information command in any view to check the micro SD card installation and file system mounting status. If SD Card Physical State is Present and SD Card File System State is Mounted, the micro SD card is working properly.
- If SD Card Physical State is Absent, re-install the micro SD card and try again. If SD Card Physical State remains the same, the USG may fail to identify the micro SD card. You are advised to use another micro SD card.
- If SD Card File System State is Unmounted, the micro SD card format might not be ext4. You need to run the reset sd-card command in the system view to format the micro SD card.