Powering On or Off the USG6510E, USG6510E-POE, USG6530E
This section describes how to power on or off the USG6510E, USG6510E-POE, USG6530E. To ensure the normal start and security of the USG6510E, USG6510E-POE, USG6530E, strictly follow the operation guide to power on or off the USG6510E, USG6510E-POE, USG6530E.
Context
- The power cable and PGND cable are properly connected.
- The power switch in the equipment room is easy to locate so that you can power off devices in the case of accidents.
Procedure
- Power on the USG.
The USG starts after the switch of the power supply device is turned on.
You can identify the USG status based on indicators on the front panel. Indicators shown in Figure 5-19 indicate that the USG is running normally.
- Power off the USG.
Before powering off the USG, ensure that configuration data is saved. Otherwise, the configuration data may be lost.
If the USG will be administratively shut down for a long time, turn off the power switch. After powering off the USG, set it aside properly according to storage requirements.
