Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Connecting a Power Adapter
A power adapter can be used to supply power for a USG6510E, USG6510E-POE, USG6530E. Prepare an AC power cable to connect the power connector and the power source of the equipment room.
Context
Before connecting a power connector, ensure that the power source of the equipment room meets the input requirements of the USG power module.
Procedure
- Ensure that the PGND cable is properly grounded.
- Insert a cable-retention clip into the jack next to the power socket.
- Connect a power adapter.
- Plug the other end of the AC power cable to the AC power socket or the output of the AC power supply device.
The USG does not have any power switch. The power supply switch determines the power-on and power-off of the USG.
Figure 5-17 Connecting a power adapter to the (USG6510E, USG6530E)Figure 5-18 Connecting a power adapter to the (USG6510E-POE)
- Plug the other end of the AC power cable to the AC power socket or the output of the AC power supply device.
