No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Default APN

(Optional) Configuring the Default APN

Context

Some carriers require that devices connect to LTE networks through the default APN, whereas other carriers do not have such requirements. You can determine whether to configure the default APN for an LTE network based on the carrier's requirements. By default, no default APN is configured for an LTE network.

NOTE:

This configuration is not supported on the LTE data card E8278.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface cellular interface-number

    The LTE cellular interface view is displayed.

  3. Run profile create lte-default apn [ user username password password authentication-mode { chap | pap } ]

    The default APN is configured for an LTE network.

    By default, no default APN is configured for an LTE network.

    To delete the default APN configured for an LTE network, run the profile delete lte-default command.

    NOTE:

    For the 1LTE-Lt interface cards, the APN configured using the profile create lte-default command and the APN configured using the apn command overwrite each other. The two commands cannot be configured together.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20633

Downloads: 89

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next