No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the PPP Dial-Up Mode

(Optional) Configuring the PPP Dial-Up Mode

Context

By default, the LTE modem uses the standard interface defined in the network diver interface specification to connect to a 3G or an LTE network. If the carrier's device only supports the PPP dial-up mode for 3G/LTE network access, you must manually set the dial-up mode to PPP.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface cellular interface-number

    The LTE cellular interface view is displayed.

  3. Run dialer mode ppp

    The PPP dial-up mode is configured for the LTE modem to connect to a 3G or an LTE network.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20772

Downloads: 91

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next