No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Working Mode of a PON Interface

Configuring the Working Mode of a PON Interface

Context

When the router is connected to an EPON interface of an OLT, configure the router to automatically determine the working mode according to the received optical signal, or configure the PON interface connected to the OLT to work in EPON mode.

  • You are advised to configure a PON interface to work in auto-negotiation mode. To trigger another negotiation after a successful negotiation, reset the PON board. For example, if a PON interface of the router has automatically negotiated to work in EPON mode, you need to reset the PON board so that this interface can automatically negotiate to work in GPON mode when this interface connects to an OLT's PON interface that works in GPON mode.

  • If a PON interface is transmitting service data, changing the working mode will interrupt services on the PON interface. Perform this operation with caution.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface pon interface-number

    The PON interface view is displayed.

  3. Run port mode epon

    The PON interface is configured to work in EPON mode.

    By default, a PON interface automatically determines the working mode according to the received optical signal.

  4. (Optional) Run epon compatibility dba

    The compatibility mode of the EPON interface is configured.

    By default, the compatibility mode of an EPON interface is not configured.

    After running the epon compatibility dba command on a device, restart the device to make the configuration take effect.

    If the device connects to an optical line terminal (OLT) through an EPON interface and the remote OLT sends non-standard DBA packets, the physical status of the EPON interface on the device is Down. You can perform this step so that the device can process non-standard DBA packets from the remote OLT and transmit services.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 22726

Downloads: 127

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next