No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Data Transparent Transmission on E&M Interfaces

Enabling Data Transparent Transmission on E&M Interfaces

Context

As shown in Figure 10-3, before the data processing center and E&M terminal transmit E&M data, you must enable data transparent transmission on E&M interfaces so that routers can transparently transmit E&M data through the MPLS tunnel.

Figure 10-3  Enabling data transparent transmission on E&M interfaces

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface serial interface-number

    The E&M interface view is displayed.

  3. Run em passthrough enable

    Data transparent transmission is enabled on the E&M interface.

    By default, data transparent transmission is disabled on an E&M interface.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20631

Downloads: 89

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next