No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Clock Mode for a Combo Interface

(Optional) Configuring the Clock Mode for a Combo Interface

Context

A combo interface on a router is connected to an Ethernet interface that supports the clock function on the peer end. To exchange data successfully, interfaces on the two communicating parties must work in clock synchronization state.

A combo interface works in either of the following clock modes:

  • Master: uses clock signals provided by the interface card.
  • Slave: uses line clock signals.

When a router is connected to an Ethernet interface on the peer end and both the connected interfaces support the clock function, you must configure the interfaces to work in master and slave clock modes respectively.

  • When you manually specify the clock modes of the two interfaces, you must configure one interface to work in master clock mode and the other in slave clock mode.
  • When you manually specify the clock mode of an interface and configure the other interface to automatically select the clock mode, the other interface will automatically select the clock mode opposite to the specified the clock mode of the peer interface.
  • When you configure both the interfaces to automatically select the clock mode, the interfaces will select different clock modes.
NOTE:

Only the Ethernet electrical interface (with the rate of 1000 Mbit/s) on the 4GECS interface card supports the clock mode configuration. Before performing this task, verify that the combo interface works in electrical mode and its interface rate is 1000 Mbit/s.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface gigabitethernet interface-number

    The GE interface view is displayed.

  3. Run clock [ auto perfer ] { master | slave }

    The clock mode is configured on the combo interface.

    By default, a combo interface automatically selects the clock mode, and preferentially works in slave clock mode to use line clock signals.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21388

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next