No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Dialer Interface

Configuring a Dialer Interface

By binding a physical interface (such as a serial, BRI or asynchronous interface) to a dialer interface, you can enable the physical interface to inherit the configuration of the dialer interface.

Context

The dial control center (DCC) provides the dialing service for users. You can configure DCC on the routers connected by Network or on the routers functioning as a PPPoE/PPPoEoA/PPPoA client connecting to a PPPoE/PPPoEoA/PPPoA server.

A dialer interface is a logical interface used to implement DCC. A physical interface can be bound to a dialer interface to inherit the configuration of the dialer interface.

Applicable Environment

Before configuring a dialer interface, complete the following task:
  • Powering on the device and performing self-check

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface dialer number

    A dialer interface is created.

  3. Configure an IP address of a dialer interface.

    • Configure an IP address for a dialer interface directly.

      Run

      ip address ip-address { mask | mask-length }

      An IP address is configured for the dialer interface.

    • Configure an IP address assigned by the peer device for a dialer interface.

      Run

      ip address ppp-negotiate

      The local dialer interface is configured with an IP address that is assigned by the peer device through PPP negotiation.

  4. Configuring a Dialer Interface

    For details about how to configure a dialer interface, refer to DCC Configuration in Huawei AR100&AR120&AR150&AR160&AR200&AR1200&AR2200&AR3200&AR3600 Series Enterprise Routers Configuration Guide: WAN Configuration.

Verifying the Configuration

  • Run the display interface dialer command to check the status of the dialer interface.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20852

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next