No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Automatically Restarting a 3G Modem

Automatically Restarting a 3G Modem

Context

When a 3G modem is not attached to a Packet Switch (PS) domain, you can configure the 3G modem to automatically restart and set the interval at which the 3G modem automatically restarts. Then the 3G modem automatically restarts and starts dialing until it is attached to a PS domain.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the interface cellular interface-number command to enter the 3G cellular interface view.
  3. Run the packet-service recover interval command to configure the 3G modem to automatically restart and set the interval at which the 3G modem automatically restarts.

    By default, a 3G modem does not automatically restart.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21179

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next