No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Compatibility Mode of the Uplink G.SHDSL Interface

Setting the Compatibility Mode of the Uplink G.SHDSL Interface

Prerequisites

The G.SHDSL interface has been deactivated.

Context

To enable the device to connect to the peer device, run the shdsl compatibility command to configure the capability for the G.SHDSL interface based on the chip type of the peer device.

To enable the device to connect to the peer device, set the probe mode, vendor ID, and interoperatability mode for the device.

Table 18-2  Compatibility mode of the G.SHDSL interface

Compatibility Mode

Subtype

Probe mode

normal indicates the standard probe mode.

long indicates the probe mode that is compatible with the receiver equipped with Globespan chip 2.5.x or 3.0.x.

Vendor ID

normal indicates the device vendor ID.

gs indicates Globespan vendor ID.

gs enhanced indicates enhanced Globespan vendor ID.

The peer device with Globespan vendor ID will disconnect from the router that has an ID different from Globespan vendor ID. To solve the problem, set the vendor ID to Globespan vendor ID.

NOTE:
If the router configured with Globespan vendor ID cannot communicate with the peer device, configure enhanced Globespan vendor ID.

Interoperatability mode

normal indicates the default mode.

specific indicates the mode in which the device can identify signals sent by the peer device when the device connects to the peer device equipped with Globespan chip of earlier version and the rate is less than 512 kbit/s, and the power spectral density (PSD) mode does not comply with standards.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run either of the following commands to enter the G.SHDSL interface view.
    • If the transmission mode is set to ATM, run:
      interface atm interface-number
    • If the transmission mode is set to PTM, run:
      interface ethernet interface-number
  3. Run shdsl compatibility pmms { normal | long } vendor { normal | gs [ enhanced ] } filter { normal | specific }

    The compatibility mode of the G.SHDSL interface is set.

    By default, a G.SHDSL interface uses the normal compatibility mode.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21398

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next