No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Local and Remote Interfaces Have Different Duplex Modes, Rates, and Negotiation modes

Local and Remote Interfaces Have Different Duplex Modes, Rates, and Negotiation modes

Fault Description

An interface frequently alternates between Up and Down.

Troubleshooting Procedure

  1. Run the
    display interface [ interface-type [ interface-number ] ]
    command to check the duplex mode, speed, and negotiation mode of the interface.
    • View the Negotiation field.
      1. ENABLE: indicates that the interface works in auto-negotiation mode.
      2. DISABLE: indicates that the interface works in non-auto negotiation mode.

      The two interfaces must work in the same negotiation mode. Run the negotiation auto command in the interface view to enable auto negotiation on the interfaces. If the fault persists, disable auto negotiation and forcibly set the same speed and duplex mode on the interfaces.

    • View the Speed field. If the two interfaces work at different speeds in the non-auto negotiation state, run the speed command in the interface view to set the same rate on the two interfaces.
    • View the Duplex field. If the two interfaces work in different duplex modes in non-auto negotiation mode, run the duplex command in the interface view to set the same duplex mode on the two interfaces.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21147

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next