No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Transmission Standard for a G.SHDSL Interface

Setting the Transmission Standard for a G.SHDSL Interface


The G.SHDSL interface has been deactivated.


The device supports the following transmission standards:

  • G.991.2 Annex A and G.991.2 Annex F are North American standards.

  • G.991.2 Annex B and G.991.2 Annex G are European standards.

A G.SHDSL interface must use the same transmission standard as the remote G.SHDSL interface on the DSLAM.


  1. Run system-view

    The system view is displayed.

  2. Run either of the following commands to enter the G.SHDSL interface view.
    • If the transmission mode is set to ATM, run:
      interface atm interface-number
    • If the transmission mode is set to PTM, run:
      interface ethernet interface-number
  3. Run shdsl annex { a | all | b }

    The transmission standard is set for the G.SHDSL interface.

    By default, a G.SHDSL interface supports both G.991.2 Annex A, G.991.2 Annex F, and G.991.2 Annex B, and G.991.2 Annex G and can adapt to the transmission standard used by the remote G.SHDSL interface on the DSLAM.

Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20987

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next