No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VDSL Interface to Work in ATM Mode

Configuring a VDSL Interface to Work in ATM Mode

Context

The device supports two working modes for VDSL interfaces: ATM for transmitting ATM cells and PTM for transmitting Ethernet frames.

The device functions as a CPE. A VDSL interface on the device must work in the same mode as the VDSL interface on the DSLAM.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run set workmode slot slot-id vdsl atm

    A VDSL interface is configured to work in ATM mode.

    By default, VDSL interfaces work in PTM mode.

    NOTE:

    After running the set workmode vdsl command, you need to restart the card or device and wait for a period of time to make the configuration take effect.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20671

Downloads: 89

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next