No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Cannot a 3G Dial-up Connection Be Established Immediately When the 3G Link Is Used as the Backup Link?

Why Cannot a 3G Dial-up Connection Be Established Immediately When the 3G Link Is Used as the Backup Link?

In most cases, 3G links are used as backup links of routers. When the primary link fails, the backup 3G link needs to immediately establish a dial-up network connection, which prevents the impact on services. However, sometimes when the primary links have a fault, the backup links fail to establish a dial-up connection immediately, and the establishment may even take several minutes.

The possible causes are as follows:

  1. The signal of the network provided by the carrier is poor.
  2. The automatic dial-up interval is too long.

Use the following check methods:

  1. Run the display cellular interface-number radio command to check the Current RSSI field and check received signal strength. If the RSSI is larger than or equal to -85 dBm, signals are stable and reliable.
  2. If the signal is normal and the 3G cellular interface uses automatic dial-up, run the display this command in the 3G cellular interface view to check the automatic dial-up interval. If the automatic dial-up interval is too long, run the dialer timer autodial command to shorten the interval so that the service interruption period can be reduced when 3G links are used as backup links.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21320

Downloads: 97

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next