No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the PSD Mode for a G.SHDSL Interface

Setting the PSD Mode for a G.SHDSL Interface

Prerequisites

The G.SHDSL interface has been deactivated.

Context

The router must be configured with the same power spectral density (PSD) mode as the peer device. The router supports the following PSD modes:

  • Symmetric PSD: The G.SHDSL interface is spectral-compatible with other services, uses less power, and is suitable for short-distance transmission.

  • Asymmetric PSD: The G.SHDSL interface uses a high output power for better transmission performance and is suitable for long-distance transmission.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run either of the following commands to enter the G.SHDSL interface view.
    • If the transmission mode is set to ATM, run:
      interface atm interface-number
    • If the transmission mode is set to PTM, run:
      interface ethernet interface-number
  3. Run shdsl psd { asymmetry | symmetry }

    The PSD mode is set for the G.SHDSL interface.

    By default, the PSD mode of a G.SHDSL interface is symmetric PSD.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 22915

Downloads: 129

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next