No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Working Mode for an SHDSL Interface

Setting the Working Mode for an SHDSL Interface

Prerequisites

The G.SHDSL interface has been deactivated.

Context

The G.SHDSL interface can work in CO or CPE mode.

When two devices establish a back-to-back connection, one device must work in CO mode and the other device must work in CPE mode.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run either of the following commands to enter the G.SHDSL interface view.
    • If the transmission mode is set to ATM, run:
      interface atm interface-number
    • If the transmission mode is set to PTM, run:
      interface ethernet interface-number
  3. Run shdsl mode { co | cpe }

    The working mode of the G.SHDSL interface is configured.

    By default, a G.SHDSL interface works in CPE mode.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20903

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next