No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Automatically Restarting an LTE Modem

Automatically Restarting an LTE Modem


When an LTE modem is not attached to a Packet Switch (PS) domain, you can configure an LTE modem to automatically restart and set the interval at which the LTE modem automatically restarts. Then the LTE modem automatically restarts and starts dialing until it is attached to a PS domain.


  1. Run system-view

    The system view is displayed.

  2. Run interface cellular interface-number

    The LTE cellular interface view is displayed.

  3. Run packet-service recover interval

    An LTE modem is configured to automatically restart and the interval at which an LTE modem automatically restarts is set.

    By default, an LTE modem does not automatically restart.

Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20680

Downloads: 89

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next