No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring CPOS Interfaces to Converge E1 Lines

Configuring CPOS Interfaces to Converge E1 Lines

Multiple branches access the SONET/SDH network through E1 lines. To lower costs and improve the convergence ability of the device for low-speed access, the regional headquarters uses CPOS interfaces to converge these E1 lines. In this way, data can be transmitted between the regional headquarters and its branches. The E1 system is widely used in Europe and China.

Pre-configuration Tasks

Before configuring CPOS interfaces to converge E1 lines, complete the following tasks:

  • Registering the 1CPOS-155M/1CPOS-155M-W interface card

  • Ensuring that the configuration of multiplexing path TUGs on the SDH transmission device corresponds to the E1 channel number of the CPOS interface

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 22827

Downloads: 127

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next