No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Transmission Mode for a G.SHDSL Interface

Setting the Transmission Mode for a G.SHDSL Interface

Context

The router supports two transmission modes for G.SHDSL interfaces: ATM for transmitting ATM cells and PTM for transmitting Ethernet frames. The device functions as a CPE. a G.SHDSL interface on the device must work in the same mode as the G.SHDSL interface on the DSLAM.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run set workmode slot slot-id shdsl { atm | ptm }

    The transmission mode is set for G.SHDSL interfaces.

    By default, a G.SHDSL interface uses the ATM mode.

    After completing this step, reset the G.SHDSL interface card and wait for a while for the configuration to take effect.

    NOTE:
    • The SRU of AR158E, AR158EVW, AR168F, AR168F-4P and AR208E has only one WAN physical interface. After the transmission mode is set for the G.SHDSL interface card, four G.SHDSL interfaces all work in the configured mode. The AR168F and AR168F-4P interfaces are numbered from 0 to 3. In ATM mode, the AR158E, AR158EVW and AR208E interfaces are numbered from 0 to 3; in PTM mode, the AR158E and AR158EVW interfaces are numbered from 4 to 7, and AR208E interfaces are numbered from 8 to 11.
    • Each 4G.SHDSL board on the AR1200, AR2204, AR2204-51GE-P, AR2204-51GE-R, AR2204-27GE-P, AR2204-27GE, AR2204E, AR2204E-D, AR2220E, AR2220, AR2240, AR2240C, AR3200, and AR3600 has only one physical interface. This physical interface can be virtualized into four G.SHDSL upstream interfaces numbered from 0 to 3. After the transmission mode is set for the G.SHDSL interface card, four G.SHDSL interfaces all work in the configured mode.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21101

Downloads: 95

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next