No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Port Group

Configuring a Port Group

Port groups can reduce interface configuration workload.

Context

To perform the same configuration on multiple Ethernet interfaces, add these Ethernet interfaces to a port group and run commands in the port group view to configure the Ethernet interfaces in batches. This reduces the configuration workload.

You can configure the following port groups:
  • Permanent port group
  • Temporary port group

If you exit from a temporary port group view, the system automatically deletes the group.

Procedure

  • Configuring a permanent port group

    1. Run system-view

      The system view is displayed.

    2. Run port-group port-group-name

      A permanent port group is created, and the port group view is displayed.

    3. Run group-member { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-5>

      An Ethernet interface is added to the permanent port group.

  • Configuring a temporary port group

    1. Run system-view

      The system view is displayed.

    2. Run port-group group-member { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-5> or interface range { interface-type interface-number1 [ to interface-type interface-number2 ] } &<1-5>

      A temporary port group is created, and the port group view is displayed.

Verifying the Configuration

Run the display port-group [ all | port-group-name ] command to check information about a permanent port group and interfaces in the group.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 20904

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next