No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Interface Management

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the basic concepts, configuration procedures, and configuration examples of the interfaces supported by the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Working Mode of a PON Interface

Configuring the Working Mode of a PON Interface

Context

When the device is connected to a GPON interface of an OLT, configure the device to automatically determine the working mode according to the received optical signal, or configure the PON interface connected to the OLT to work in GPON mode.

  • You are advised to configure a PON interface to work in auto-negotiation mode. To trigger another negotiation after a successful negotiation, reset the PON board. For example, if a PON interface of the device has automatically negotiated to work in EPON mode, you need to reset the PON board so that this interface can automatically negotiate to work in GPON mode when this interface connects to an OLT's PON interface that works in GPON mode.

  • If a PON interface is transmitting service data, changing the working mode will interrupt services on the PON interface. Perform this operation with caution.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface pon interface-number

    The PON interface view is displayed.

  3. Run port mode gpon

    The PON interface is configured to work in GPON mode.

    By default, a PON interface automatically determines the working mode according to the received optical signal.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100069331

Views: 21047

Downloads: 93

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next